Less worry with SmartPilot control system
The SmartPilot control system monitors performance, reminds you when to change air and oil filters, and provides pre-warning of temperature and oil separation problems.

Features include:

SmartPilot
  • Automatic service interval counters
  • Four pressure units: Bar, PSI, kPa, kg/cm2
  • Two temperature units: °C and °F
  • Informative fault code system
  • Different fault code groups: compressor/drive/maintenance fault
  • RTC (Real Time Clock)
  • Active 4-20 mA output for remote pressure reading
  • RS 485 port
  • Sequencing capability, up to 3 different units (up to 12 units with meta center)
  • Remote monitoring - RS 485
  • Secondary control for discharge temperature with fully controllable oil-mixing valve (TMC 105-365)
  • Modbus protocol


Alarms for
  • High oil temperature at 110°C /shutdown at 115°C
  • High ∆P for oil separator
  • Electric motor overheating (thermistors)
  • High air outlet temperature at 65°C /shutdown at 70°C
  • High pressure (shutdown at 10% over pressure)


Different units available
  • Temperature in °C or °F
  • Four different pressure units: Bar, PSI, kPa, kg/cm2

     
    SmartPilot service

    Diagnostic system:

    Automatic information for

    • Oil change
    • Oil filter change
    • Air filter change
    • Separator filter change
    • Motor lubrication
    • Inlet and discharge seal
    • Up to 85 kW: belt change
    •

    P.O. Box 3 Furuset,
    N-1001 Oslo, Norway
    Tel: +47 22 91 85 00
    Fax: +47 22 91 84 93
    24 hour emergency phone: +47 99 21 70 20
    mail@tmc.no