Less worry with SmartPilot control system
The SmartPilot control system monitors performance, reminds you when to change air and oil filters, and provides pre-warning of temperature and oil separation problems.
Features include:
 |
- Automatic service interval counters
- Four pressure units: Bar, PSI, kPa, kg/cm2
- Two temperature units: °C and °F
- Informative fault code system
- Different fault code groups: compressor/drive/maintenance fault
- RTC (Real Time Clock)
- Active 4-20 mA output for remote pressure reading
- RS 485 port
- Sequencing capability, up to 3 different units (up to 12 units with meta center)
- Remote monitoring - RS 485
- Secondary control for discharge temperature with fully controllable oil-mixing valve (TMC 105-365)
- Modbus protocol
Alarms for
- High oil temperature at 110°C /shutdown at 115°C
- High ∆P for oil separator
- Electric motor overheating (thermistors)
- High air outlet temperature at 65°C /shutdown at 70°C
- High pressure (shutdown at 10% over pressure)
Different units available
SmartPilot service
Diagnostic system:
Automatic information for
- Oil change
- Oil filter change
- Air filter change
- Separator filter change
- Motor lubrication
- Inlet and discharge seal
- Up to 85 kW: belt change
